Enter ubnt in the Username and Password fields.Launch your web browser and type in the address field.Configure the Ethernet adapter on your host system with a static IP address on the 192.168.1.x subnet.Make sure that your host machine is connected via Ethernet to the device.Verify connectivity in the airOSĀ® Configuration Interface. This 10/100 Ethernet port is used to connect the power and should be connected to the LAN and DHCP server. To reset to factory defaults, press and hold the Reset button for more than 10 seconds while the device is powered on. The Power LED will light green when the device is connected to a power source. The Ethernet LED will light steady green when an active Ethernet connection is made and flash when there is activity. ![]() In airOSĀ®, you can modify the threshold values for the wireless signal strength LEDs on the Advanced tab under Signal LED Thresholds. The ETH-SP will absorb power surges and safely discharge them into the ground. We recommend that you use two Ethernet Surge Protectors, model ETH-SP, one near the B-DB-AC and the other at the entry point to the building. ![]()
0 Comments
Leave a Reply. |